Paver questions answered · Free estimates · Bucks County PA Get Estimate
Home/Blog/Paver questions
Question 10 · Bucks County, PA

Paver patio questions,
answered for Bucks County

A paver patio in Bucks County, PA lasts for decades when the base is built right and the surface is cleaned, re-sanded and resealed every few years. Below are short, straight answers to the paver questions homeowners ask most, from stains and weeds to salt, snow and cost, each linked to a full guide.

8 min readUpdated November 18, 2026Written by the crew that answers them every day

The short answer: most paver problems are surface or joint problems, and most are fixable without replacing anything. The questions below are the ones homeowners ask us and search for most. Each answer is short, and where a full guide exists, it links there.

How long pavers last, and are they worth it

→How long does a paver patio last?

Concrete pavers themselves last for decades. What decides a patio's life is the base under it: a patio on a properly excavated, compacted base lasts for decades with routine care, while one on a thin base can start sinking within a few years. See restore vs. replace.

→Are pavers better than a poured concrete patio?

In Pennsylvania's freeze-thaw winters, pavers have two advantages: the joints let the surface flex instead of cracking, and any section that moves can be lifted and reset with the same pavers. A cracked slab cannot be fixed invisibly. The trade-off is that paver joints need refilling every few years.

→Do pavers fade over time?

Yes. Sun and wear slowly fade paver color over the years. A deep clean brings back much of it, because a lot of what looks like fading is dirt and growth, and sealer slows further fading.

Cleaning and stains

→Can I pressure wash my pavers?

Yes, with care. Use a fan tip, keep it moving and keep it back from the surface. Too much pressure etches the paver face and blasts out the joint sand, so the joints have to be refilled afterwards. Our pressure and soft washing page explains when each is used.

→How do I get oil stains out of pavers?

On a fresh spill, soak up as much as you can with cat litter, then scrub with a degreaser or dish soap and hot water. Older stains need a paver oil-stain remover or poultice, sometimes more than once. Sealed pavers resist oil, so spills wipe up instead of soaking in.

→How do I remove rust stains from pavers?

Rust from furniture, fertilizer granules or well water comes out with a rust remover made for concrete, usually based on oxalic acid. Test a small spot first and rinse well. Sweep fertilizer off the pavers before watering to stop new stains.

→What is the green or black growth on my pavers?

Algae, moss or mildew, which grow where pavers stay damp and shaded. A low-pressure soft wash kills it without washing out the joint sand. That is what our patio maintenance visits do.

→What is the white haze on my pavers?

Usually efflorescence, a natural lime bloom from inside concrete pavers that fades with time or comes off with the right cleaner. It can also be polymeric sand residue or cloudy sealer. Our guide to white haze on pavers shows how to tell them apart.

Joints, weeds and ants

→Why do weeds keep growing between my pavers?

Because the joint sand has washed out or filled with dirt, and seeds land in it. Pulling or spraying never lasts. The fix is to clean the joints and refill them with polymeric sand. See how to stop weeds between pavers.

→How do I get rid of ants in my pavers?

Ants dig out loose joint sand and leave small mounds on the surface, which loosens the pavers over time. Insecticide only works for a while. Refilling the joints with polymeric sand, which hardens, leaves them nothing to dig.

→What is the difference between regular sand and polymeric sand?

Regular sand stays loose, so rain, wind and pressure washing carry it out of the joints. Polymeric sand has a binder that hardens after it is wetted, which locks the pavers and keeps weeds and ants out. More in why a hardscaper.

Winter care

→Can I use rock salt on my pavers?

Most concrete paver makers allow rock salt or calcium chloride in moderation, but check your paver's guidance. Avoid de-icers that contain ammonium nitrate or ammonium sulfate, which attack concrete. Rinse the salt off in spring, and use sand when you only need grip.

→Can I shovel or plow snow off pavers?

Yes. A plastic shovel, or a plow or snow blower with a rubber edge or raised shoes, is safest. Metal blades can chip paver edges and catch on any paver sitting higher than its neighbors, which is also a sign that area needs resetting.

→Does winter damage pavers?

Water does. When water gets into open joints and a soft base and freezes, it can heave pavers and sink low spots. Full joints, good drainage and sealer keep water out. Walk the patio each spring and deal with any new dips early.

Repairs, sinking and sealing

→Can a single cracked or broken paver be replaced?

Yes. The broken paver is cut or lifted out and a new one is set in its place. If you have spares from the original job, use them. A new paver can look slightly brighter than its weathered neighbors at first, and cleaning the area evens it out.

→Why are some of my pavers sinking?

Something under them moved: a thin or uncompacted base, water from a downspout or bad slope, washed-out joint sand or a missing edge restraint. See why pavers sink and how paver resetting works.

→Do pavers have to be sealed?

No, but sealing protects them. It slows fading, makes stains wipe up and helps hold the joint sand in place. Most Bucks County patios need it every 2 to 4 years. See how often to seal pavers.

→Should I restore or replace my paver patio?

Restore it if the pavers are sound and the problems are dirt, weeds, washed-out joints or a few low spots. Replacement only makes sense when the pavers are crumbling or the base has failed under most of the patio. Our restore vs. replace guide walks through it.

Paver questions about cost and hiring in Bucks County

→How much does paver restoration cost in Bucks County?

A basic paver restoration (clean and re-sand) from Petra Power Solutions starts at $750, and sealing is $1.50–$2.50 per sq ft. Resetting sunken areas is quoted on site. Estimates are free, and small jobs can often be quoted from photos.

→How much does a new paver patio cost?

Every new patio is custom quoted after a free on-site visit, because the price depends on size, paver choice, access and how much base work the ground needs. See patio installation.

→Should I hire a landscaper or a hardscaper for pavers?

A hardscaper. Paver work depends on base preparation, drainage, edge restraints and correctly installed polymeric sand, and none of those can be seen once the job looks finished. Read why a hardscaper.

→Which towns do you serve for paver work?

We clean, repair, reset and seal pavers across Bucks County, including Newtown, Yardley, Doylestown, Langhorne and the rest of our service area. Estimates are free. We reply within 2 hours during business hours.

Next question

Keep reading.

Get started

Got a paver
question?

Free estimate, often from photos. Owner on every job, fully insured, and straight answers about your pavers.

Now booking December · Weekend slots fill first
Call (267) 331-1990 Get a Free Estimate

No obligation·Free estimate often by photo·61 Google reviews, 5.0★·Newtown, PA

Serving Bucks County, PA

Petra Power Solutions builds and restores hardscape across Newtown PA, Yardley PA, Doylestown PA, New Hope PA, Langhorne PA, Richboro PA, Horsham PA, Jamison PA, Washington Crossing PA, and Buckingham PA. Owner-operated since 2022. Free estimates. Call (267) 331-1990.

Free Estimate Call Now