The short answer: the weed is not the problem, the empty joint is. Pulling, spraying or burning weeds clears what you can see, but the open joint fills with dirt and seeds again within weeks. Fixing the joint is what stops the cycle.
Why weeds grow between pavers
Very few weeds come up through a properly built base. Almost all of them start from seeds that land in the joints from above. They take hold when the joint gives them something to grow in:
- Washed-out joint sand. Rain, downspouts and pressure washing slowly empty the joints, and plain sand washes out fastest.
- Dirt and organic debris. Leaves, pollen, mulch and grass clippings break down in the joints into a thin layer of soil.
- Shade and moisture. Joints that stay damp under trees or along the north side of the house grow moss and algae as well as weeds.
- Low spots and gaps. Areas that hold water, and open gaps along the edges, collect seeds and stay wet. Those are a resetting job, not just a weeding one.
Quick fixes, and why they don't last
Hand pulling, boiling water, weed killer and flame weeders all kill what is above the joint. None of them refills it. The roots that survive grow back, new seeds land in the same dirt, and the joint keeps losing sand. Household vinegar is acidic and, used over and over, can dull concrete pavers and natural stone. Rock salt used as a weed killer can damage the lawn and beds along the edges.
Blasting the weeds out with a pressure washer also blasts out the joint sand. If the joints are not refilled afterwards, you are left with deep, empty gaps that fill with seeds faster than before.
The permanent fix: clean, re-sand and seal
- Deep clean the surface and joints. Weeds, roots, dirt and old sand come out of the joints, and the surface is cleaned.
- Let it dry completely. Polymeric sand only works in dry joints, so this step is never rushed.
- Refill with polymeric sand. Commercial polymeric sand is swept in to full depth and compacted, the surface is blown clean, and the sand is misted to activate the binder. It hardens into a firm joint that seeds cannot root in and rain does not wash out.
- Seal, if you want. Once the sand has cured, sealer helps hold it in place against rain and makes the surface easier to keep clean. See how often to seal pavers.
That is the core of a paver restoration, and it usually takes 1 to 3 days start to finish. The reason we use commercial polymeric sand rather than the box-store product is explained in why a hardscaper.
Moss and algae in shady joints
Green or black growth in shaded joints is moss, algae or mildew rather than weeds. A low-pressure soft wash kills it without blasting out the joint sand, which is how our patio maintenance visits work. If a spot stays wet because water pools there, the long-term fix is getting the water to drain away.
Keeping weeds out after the fix
- Sweep or blow off leaves and debris before they break down in the joints.
- Rinse at low pressure, never with a narrow tip aimed into the joints.
- Pull the odd seedling while it is small. In a hardened joint it comes out easily.
- Reseal when water stops beading on the surface.
If you would rather not think about it, our care plan puts the cleaning and joint checks on a schedule.
What it costs in Bucks County
A basic paver restoration (clean and re-sand with polymeric sand) starts at $750, and sealing is $1.50–$2.50 per sq ft. The estimate is free, small jobs can often be quoted from photos, and the written quote comes before any work starts.